Enter Keys Manually in Ariza Extreme FTA Receiver

1. Press “Menu” on remote

2. Press right arrow to “Expert” with remote.

3. Press “1-2-3-4” quickly on remote. This will bring you into the “CAS system”
Menu. This is where you enter/alter data for all services you wish to test.

4. using the arrow keys to navagate , move to the appropriate index for the desired provider, then to the key & select “ok” on remote.

5. Using the arrow keys on remote to change selected values for the desired provider/key.

6. Using your remote, select and change the “key 00 data” with new correct information, then press “exit” on remote to store your changes.

7. Using your remote, select and change the “key 01 data” using the same method described for changing key 00 ,steps 4 -6 substituting the key 01 index/key line and correct data for key 01. Enter the new 01 data, then select “exit” on the remote to store your changes.

8. Press “exit” on remote untill you reach view mode, then wait approx 15 seconds and your reciever should beging to process correctly again, allowing you to view video again until the next change. You must then obtain current/new data and repeat this process over again substituting the new updated data.

9. If after completing all listed steps you still fail to recieve video , then review all
data as entered as well as all setup and installation settings ensuring they are
correct and you are recieving signal from the correct satellites.